The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl Simulators >> RF Simulators >> A question about the simulation of PA https://designers-guide.org/forum/YaBB.pl?num=1176698388 Message started by calven on Apr 15th, 2007, 9:39pm |
Title: A question about the simulation of PA Post by calven on Apr 15th, 2007, 9:39pm hi! i am designing a PA for IEEE 8012.11b 11MB/S WLAN applications.i do not know how to simulate its ACPR with spectreRF.Has anyone done this?Please tell me the detailed method.thanks a lot! |
Title: Re: A question about the simulation of PA Post by sigdel_pll on Apr 20th, 2007, 12:13pm Try cadence "source link", load pull simulation, I remember seeing some example on how to set up acpr simulation |
Title: Re: A question about the simulation of PA Post by vivarf on May 30th, 2007, 9:50pm I finally find out this one: http://www.cadence.com/community/virtuoso/resources/SpectreRF_PA533AN.pdf It is an great example of RF amplifier design, the setup and simulation of Load pull and ACPR are described in detail. |
The Designer's Guide Community Forum » Powered by YaBB 2.2.2! YaBB © 2000-2008. All Rights Reserved. |