The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl Design >> RF Design >> Which Bits in Bluetooth EDR Mode Determing 2M or 3 https://designers-guide.org/forum/YaBB.pl?num=1187074766 Message started by qiushidaren on Aug 13th, 2007, 11:59pm |
Title: Which Bits in Bluetooth EDR Mode Determing 2M or 3 Post by qiushidaren on Aug 13th, 2007, 11:59pm Hi all, In Bluetooth EDR mode where are the control bits which control whether the data rate is 2M or 3M? Best regards, Terry |
Title: Re: Which Bits in Bluetooth EDR Mode Determing 2M Post by didac on Aug 14th, 2007, 6:27am Hi Terry, I haven't worked with Bluetooth for a while but if you look at the specs in page 40 it tells you wich bits of LMP indicate each mode, also in page 390 you have the mask of the LMP PDU. Hope it helps, |
The Designer's Guide Community Forum » Powered by YaBB 2.2.2! YaBB © 2000-2008. All Rights Reserved. |