The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl Simulators >> AMS Simulators >> Scilab w/t verilog-AMS(for Cadence) https://designers-guide.org/forum/YaBB.pl?num=1289813592 Message started by sand_dolphin2 on Nov 15th, 2010, 1:33am |
Title: Scilab w/t verilog-AMS(for Cadence) Post by sand_dolphin2 on Nov 15th, 2010, 1:33am Hi there. Now i try to check behavior of digital filter which made by function of Scilab. http://www.scilab.org/ I had made analog signal by verilog-AMS for checking behavior of this digital filter.So,this function is not verilog-D but function of Scilab. At first, i want to try to this for third order IIR filter. i want reduce tern around time to build and rebuild verilog-D for checking this function till fixing algorithm of Sciliab function. should i use MATLAB for these needs !? but i've never use MATLAB... plz give me some good advices for this way... . |
Title: Re: Scilab w/t verilog-AMS(for Cadence) Post by sheldon on Nov 15th, 2010, 10:08am Sand Dolphin, May not be exactly what you are looking for but if you use Virtuoso ViVA, look in File --> Export... in the file options there is the option to dump the waveform in MATLAB format. If Scilab can read the file, then you could directly input the results from the simulator to Scilab. This should improve turn-around time for filter development. NOTE: ViVA also supports *.csv Best Regards, Sheldon |
Title: Re: Scilab w/t verilog-AMS(for Cadence) Post by sand_dolphin2 on Nov 15th, 2010, 3:10pm ^ any thx for your kind to reply my poor question in always. sheldon wrote on Nov 15th, 2010, 10:08am:
just i want to know Can cadence's AMSDesigner co-simulate w/t Scilab ? Yes/No if Yes, i want to know how to use this co-simulation and what should i care for this.. if No, what should i do for the better way to co-simulate before defining architecture of digital filter. ( before coding verilog-D ) and i'll check Scilab's function to read Cadence's output file for MATLAB. anyone who have experience using Scilab on Cadence AMSD ? ;) |
Title: Re: Scilab w/t verilog-AMS(for Cadence) Post by sand_dolphin2 on Nov 18th, 2010, 12:30am I try to use MATLAB... thx... |
The Designer's Guide Community Forum » Powered by YaBB 2.2.2! YaBB © 2000-2008. All Rights Reserved. |