The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl Design >> Analog Design >> how to get the output pulse https://designers-guide.org/forum/YaBB.pl?num=1354801436 Message started by lhlbluesky_lhl on Dec 6th, 2012, 5:43am |
Title: how to get the output pulse Post by lhlbluesky_lhl on Dec 6th, 2012, 5:43am as the picture shows, A is input (T period of burst, T period of idle time, ......), following four divide by 2 circuit, with output B,C,D,E, and rising-edge trigging. i want to get the output as the above waveform shows, that is, after ending of A, B is reset to zero immediately (waiting for next A burst pulse), and after ending of B, C is reset to zero immediately, and so on. but the actual result is as the below waveform shows, not as i desired. what should i do to get the above waveform, or how to reset the output to zero immediately after ending of the input? thanks all. |
The Designer's Guide Community Forum » Powered by YaBB 2.2.2! YaBB © 2000-2008. All Rights Reserved. |