The Designer's Guide Community Forum

The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl
Design >> RF Design >> how to define psin for class AB and class E PAs?
https://designers-guide.org/forum/YaBB.pl?num=1075831037

Message started by sealion on Feb 3^rd, 2004, 9:57am

Title: how to define psin for class AB and class E PAs?
Post by sealion on Feb 3^rd, 2004, 9:57am

pls help me how to define the psin of input and output ports when simulate class AB and class E PAs by using spectreRF, i'm a new user, thanks for your reply.

Title: Re: how to define psin for class AB and class E PA
Post by Andrew Beckett on Feb 5^th, 2004, 2:44pm

Your question is a little vague - but one thing I would
recommend is to use the "port" component rather
than "psin" - it's a more direct map to spectre's port
component, and it is considerably easier to use.

Without knowing what you're trying to measure, nobody
will be able to advise you how to set it up...

Regards,

Andrew.

Title: Re: how to define psin for class AB and class E PA
Post by sealion on Feb 15^th, 2004, 12:07pm

You are right, I'm a new user, can you tell me how to define them?
Thanks a lot!

Sealion

Title: Re: how to define psin for class AB and class E PA
Post by Andrew Beckett on Mar 4^th, 2004, 9:14am

Well, your reply was also vague, so no I can't tell you
how to define them. I still don't know what you're trying to measure.

Andrew (without his ESP headgear on)