The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl Measurements >> Other Measurements >> Re: ADC Testing Question https://designers-guide.org/forum/YaBB.pl?num=1089972031 Message started by ywguo on Oct 1st, 2004, 9:49pm |
Title: Re: ADC Testing Question Post by ywguo on Oct 1st, 2004, 9:49pm Hello, Froggy, Would you give more details about your testing method, instrument, and result? I thought it was difficult for those guys who were willing to help you if NOT in the light of your test procedure. Best regards, Yawei |
Title: Re: ADC Testing Question Post by Paul on Oct 6th, 2004, 1:02pm Hello Froggy, typically you design your ADC for a given sampling frequency (or a range of sampling frequencies). In measurement, you sweep the signal frequency over the possible input range up to Nyquist frequency. I am not sure what you mean by "when the ADC sampling frequency increase from low frequency to Nyquist frequency", does it mean you undersample the signal? Paul |
The Designer's Guide Community Forum » Powered by YaBB 2.2.2! YaBB © 2000-2008. All Rights Reserved. |