The Designer's Guide Community Forum

The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl
Simulators >> Circuit Simulators >> How to evaluate resistance for simulation of differential circuit????
https://designers-guide.org/forum/YaBB.pl?num=1231747377

Message started by Yutao Liu on Jan 12^th, 2009, 12:02am

Title: How to evaluate resistance for simulation of differential circuit????
Post by Yutao Liu on Jan 12^th, 2009, 12:02am

Dear all,
I simulate a differential amplifier with balanced/unbalanced convertors as mentioned in "a Test Bench for Differential Circuit".
But I don't quite understand how to determine the value of the Rid, Ric, Rod and Roc.

Title: Re: How to evaluate resistance for simulation of differential circuit????
Post by pancho_hideboo on Jan 12^th, 2009, 7:15am

Yutao Liu wrote on Jan 12^th, 2009, 12:02am:

But I don't quite understand how to determine the value of the Rid, Ric, Rod and Roc.

Set these values as termination or load conditions you like.
No one except for you knows termination or load conditions you like.