The Designer's Guide Community Forum

The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl
Modeling >> Passive Devices >> Laser-Metal-Fuses
https://designers-guide.org/forum/YaBB.pl?num=1235566529

Message started by Berti on Feb 25^th, 2009, 4:55am

Title: Laser-Metal-Fuses
Post by Berti on Feb 25^th, 2009, 4:55am

Dear all,

I have studied the following post:
http://www.designers-guide.org/Forum/YaBB.pl?num=1215137612/4#4

However, for the technology I am using the given off-resistance of a (metal-)laser-fuse is very high (>1MΩ). I am wondering if I the off-resistance might be much lower (due to e.g. splattered metal)? I also wonder how much distance I should keep between fuse and circuit (e.g. vt-shift due to heat from laser?).
Does anybody has experience?

Regards