The Designer's Guide Community Forum

The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl
Other CAD Tools >> Entry Tools >> Controlling Width of Body Contact in Cadence Virtuoso using Modgen
https://designers-guide.org/forum/YaBB.pl?num=1296558847

Message started by computaholic on Feb 1^st, 2011, 3:14am

Title: Controlling Width of Body Contact in Cadence Virtuoso using Modgen
Post by computaholic on Feb 1^st, 2011, 3:14am

Hello,

my Problem is pretty specific, but i do hope that someone out there is able to help me.

I am using Cadence Virtuoso Layout GXL IC6.1.4. I have a few Transistors within a Modgen and now i would like to add a body contact to them. This can be done using the Modgen Editor. The Problem is, i cannot figure out how to control the width of the created body contact (more specific: the width of the Metal 1 Layer) . Does anybody know how to do that?