The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl
Other CAD Tools >> Entry Tools >> Flexible pin naming convention for cells in Cadence Schematic Composer
https://designers-guide.org/forum/YaBB.pl?num=1303344152

Message started by naras on Apr 20th, 2011, 5:02pm

Title: Flexible pin naming convention for cells in Cadence Schematic Composer
Post by naras on Apr 20th, 2011, 5:02pm

Dear group members,
This is my first post.
I would like to know the most compact and flexible way of expressing pin and bus naming convention, for a scenario as described:
A block(cell) takes in 32 inputs of 16 bit bus width (and produces output, say similar as input).
It will be highly laborious task to give names of the pins as in1<15:0>, in2<15:0>, in3<15:0>,....in32<15:0> and so on..
And instead of 32 input pins is there a way to have just a single pin of 32*16 bit wide.

Any help in this regard is laudable.

The Designer's Guide Community Forum » Powered by YaBB 2.2.2!
YaBB © 2000-2008. All Rights Reserved.