The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl
Measurements >> RF Measurements >> wafer probing with die on PCB
https://designers-guide.org/forum/YaBB.pl?num=1341454886

Message started by aaron_do on Jul 4th, 2012, 7:21pm

Title: wafer probing with die on PCB
Post by aaron_do on Jul 4th, 2012, 7:21pm

Hi all,


I have a design where the input port needs to be probed directly on the wafer, while the output should be from an SMA port on the PCB.

Is it possible to probe a die which is already soldered onto a PCB? My main concern is whether the plane of the die will be horizontal enough for proper probing. If you have any experience with this please share.


thanks,
Aaron

The Designer's Guide Community Forum » Powered by YaBB 2.2.2!
YaBB © 2000-2008. All Rights Reserved.