The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl
Modeling >> Semiconductor Devices >> how to define interface traps in atlas tool??
https://designers-guide.org/forum/YaBB.pl?num=1395290068

Message started by biju4u90 on Mar 19th, 2014, 9:34pm

Title: how to define interface traps in atlas tool??
Post by biju4u90 on Mar 19th, 2014, 9:34pm

how to define interface traps in atlas tool??

Title: Re: how to define interface traps in atlas tool??
Post by Jerus on Apr 15th, 2014, 8:06am

There is a dedicated statement for this: INTTRAP.

If you only want to apply traps in the interface between two regions, you should specify it using: intnumber=n/m (where n and m are de numbers of the regions that you should have defined above)


The Designer's Guide Community Forum » Powered by YaBB 2.2.2!
YaBB © 2000-2008. All Rights Reserved.