The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl
Measurements >> RF Measurements >> FPGA from / to PC Data and test equipement
https://designers-guide.org/forum/YaBB.pl?num=1399480640

Message started by issam on May 7th, 2014, 9:37am

Title: FPGA from / to PC Data and test equipement
Post by issam on May 7th, 2014, 9:37am

Hello,
In fact, I'm working on a project which aims to implement a reconfigurable Zigbee tranceiver on XUPV5-LX110T Evaluation platform which integrates a Virtex 5 FPGA. I am currently in the phase of real test.
First, I want to send my data from a PC to FPGA and receive it (to treat my signals on Matlab). Is this possible or not? If yes, Is there a solution for it using a medium of communication (e.g. serial link)
Second, is there a measuring equipment and testing (e.g. Agilent or National Instruments using PXI) which supports the Zigbee wireless protocol or otherwise IEEE 802.15.4 standard (i.e. RF Vector Signal Generator and Vector Signal Analyzer) of the analog front-end either in transmission or reception?
And thanks a lot in advance for everyone.

The Designer's Guide Community Forum » Powered by YaBB 2.2.2!
YaBB © 2000-2008. All Rights Reserved.