The Designer's Guide Community Forum

The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl
Other CAD Tools >> Entry Tools >> overbar for inverted pin name
https://designers-guide.org/forum/YaBB.pl?num=1424969629

Message started by Shahriar on Feb 26^th, 2015, 8:53am

Title: overbar for inverted pin name
Post by Shahriar on Feb 26^th, 2015, 8:53am

Hi,

I'm not sure if this is the right forum to ask this question. Is there any way to create a pin name with overbar in schematic and layout? For example, if I an inverter cell with input A, I want the output name to be A with a bar over it (NOT A).

Thanks in advance.

Title: Re: overbar for inverted pin name
Post by boe on Feb 28^th, 2015, 3:45am

Shahriar,
using which tool?
- B O E

Title: Re: overbar for inverted pin name
Post by Shahriar on Mar 1^st, 2015, 1:36am

I'm using cadence ic614. I'm trying to create a schematic symbol Where I want to make a pin with inverted logic. I have to do the same in the corresponding layout, too.it

Title: Re: overbar for inverted pin name
Post by boe on Mar 4^th, 2015, 11:21pm

Shahriar,
the object property dialog allows you to enable "Overbar" for labels.
If you enable this, "_name_" is shown as "name" with overbar.
- B O E