The Designer's Guide Community Forum

The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl
Modeling >> Transmission Lines and Other Distributed Devices >> ADS momentum hangs during EM simulation of balun
https://designers-guide.org/forum/YaBB.pl?num=1458071722

Message started by mixed_signal on Mar 15^th, 2016, 12:55pm

Title: ADS momentum hangs during EM simulation of balun
Post by mixed_signal on Mar 15^th, 2016, 12:55pm

Hi,
I am trying to simulate a balun in TSMC65nm process using momentum. Smaller baluns simulate well. But when balun is large it hangs. Is there any solution?

Should I reduce layers in the substarte by calculating average permitivity?

I am using windows 7 and RAM is 12GB.