The Designer's Guide Community Forum

The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl
Other CAD Tools >> Physical Verification, Extraction and Analysis >> Incorrect hierarchical Calibre PEXR extraction
https://designers-guide.org/forum/YaBB.pl?num=1467711319

Message started by pazhasi on Jul 5^th, 2016, 2:35am

Title: Incorrect hierarchical Calibre PEXR extraction
Post by pazhasi on Jul 5^th, 2016, 2:35am

Hello all,

While doing Hierarchical extraction with Calibre PEXr, i am encountering incorrect dc currents. almost 80%less. I am blackboxing a component which is connected to the source of the MOS and the interconnect between source and the pin of the component is showing 20mV (which ideally should be zero) and hence the current is less.. Any ideas ?.. In calibre pex, hcells of the component is added and the LVS box command is used. The PEX finshes without any error..