The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl Simulators >> Circuit Simulators >> Evaluating PSD of Opamp/Data Converter in MATLAB from Cadence Spectre https://designers-guide.org/forum/YaBB.pl?num=1505077739 Message started by repah on Sep 10th, 2017, 2:08pm |
Title: Evaluating PSD of Opamp/Data Converter in MATLAB from Cadence Spectre Post by repah on Sep 10th, 2017, 2:08pm Hello, I am designing various opamps and data converters in Cadence Spectre and would like to use MATLAB to generate Power Spectrum Density (PSD) plots of them. I do not have the Cadence MATLAB toolbox installed and would like to do this without the toolbox. Do I expert the traces directly out as .csv files and then process them in MATLAB to generate the associated PSDs ? Is there another way ? Any direction or help or advice regarding this would be helpful - or a tutorial. I am designing a Discrete Time Sigma Delta Modulator and would like to check the PSD of my opamps, system simulations of the converter and the transistor level converter also. I am looking to compare the associated PSDs of all of these associated configurations. Thank you! |
Title: Re: Evaluating PSD of Opamp/Data Converter in MATLAB from Cadence Spectre Post by Andrew Beckett on Sep 11th, 2017, 3:36am The same question was asked (and answered) here: https://community.cadence.com/cadence_technology_forums/f/92/t/37726 |
The Designer's Guide Community Forum » Powered by YaBB 2.2.2! YaBB © 2000-2008. All Rights Reserved. |