The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl Simulators >> Circuit Simulators >> bsimimg model in cadence https://designers-guide.org/forum/YaBB.pl?num=1517419815 Message started by abhilash_172 on Jan 31st, 2018, 9:30am |
Title: bsimimg model in cadence Post by abhilash_172 on Jan 31st, 2018, 9:30am Hi guys I am trying to plot id_vgs for 22nm nfet in cadence IC617. simulation is giving an error "Device (of this type bsimimg) doesnot support model groups." 1 - what are these model groups? i have idea about model files to be given in virtuoso ADE 2 - Does MMSIM151 base support bsimimg model simulation ? or should i try installation of hotfix? Regards Abhilash |
Title: Re: bsimimg model in cadence Post by Andrew Beckett on Feb 1st, 2018, 9:30am Supports for model groups (binned models) with bsimimg was introduced in MMSIM151 ISR4 - so subversion 15.1.0.434.isr4. It's not related to the IC version. I just tested this, and see the error you see in earlier versions, but then it works in later versions. You can tell because "spectre -h bsimimg" shows lmin/lmax parameters (amongst others) in the versions where it is supported. Regards, Andrew. |
Title: Re: bsimimg model in cadence Post by abhilash_172 on Feb 1st, 2018, 10:31am Hi Andrew, we installed MMSIM latest hotfix .Now simulations are running. Thanks for the support. Regards Abhilash |
The Designer's Guide Community Forum » Powered by YaBB 2.2.2! YaBB © 2000-2008. All Rights Reserved. |