The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl
Simulators >> Circuit Simulators >> SAR ADC Cadence to Matlab
https://designers-guide.org/forum/YaBB.pl?num=1543519852

Message started by repah on Nov 29th, 2018, 11:30am

Title: SAR ADC Cadence to Matlab
Post by repah on Nov 29th, 2018, 11:30am

Hello,

I am designing a SAR ADC in Cadence Virtuoso/Spectre and want to export the output of the DAC to MATLAB.

Is there a way to automate this in Cadence Virtuoso - a file write block in Verilog-A ?

Is this publicly available, included in Virtuoso or available somewhere else ?

Any tutorials about this available ?

Thank you.

Title: Re: SAR ADC Cadence to Matlab
Post by DanielLam on Nov 29th, 2018, 12:29pm

I suggest looking into Matlab Spectre Toolbox. You can directly pull the Cadence output data from Matlab with the cds_srr command.

The support website has examples, although it is a little hard to read. In the end, it requires a bit of trial and error to get the syntax right.

Otherwise, you can write outputs with an ocean script. I used to do this until I learned about the Matlab Spectre Toolbox.

The Designer's Guide Community Forum » Powered by YaBB 2.2.2!
YaBB © 2000-2008. All Rights Reserved.