The Designer's Guide Community Forum

The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl
Design >> Analog Design >> Simulating an ideal fully differential opamp
https://designers-guide.org/forum/YaBB.pl?num=1562607910

Message started by vm511 on Jul 8^th, 2019, 10:45am

Title: Simulating an ideal fully differential opamp
Post by vm511 on Jul 8^th, 2019, 10:45am

Hi,
I am trying to make an ideal model of a fully differential opamp to see the effect of a DC offset in a switched capacitor amplifier topology. In order to simulate a fully differential amplifier, I am taking two VCVS, and putting a limit on its maximum and minimum voltage in order to get the desired output voltage. Is this the correct way of emulating the constant output common mode voltage of the amplifier?