The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl Simulators >> Circuit Simulators >> Plotting On Resistance of a Bootstrapped Switch https://designers-guide.org/forum/YaBB.pl?num=1566349374 Message started by repah on Aug 20th, 2019, 6:02pm |
Title: Plotting On Resistance of a Bootstrapped Switch Post by repah on Aug 20th, 2019, 6:02pm How does one plot the on resistance of a bootstrapped switch ? |
Title: Re: Plotting On Resistance of a Bootstrapped Switch Post by Geoffrey_Coram on Aug 26th, 2019, 6:51am You probably want 1/GDS of the transistor. You'll need to provide more information (eg, what simulator?) if you need more help than that. |
Title: Re: Plotting On Resistance of a Bootstrapped Switch Post by Ken Kundert on Aug 26th, 2019, 12:45pm Connect one side of switch to DC voltage source. Then connect a current source across the switch with mag=1. Assure the switch is turned on. Perform an fixed-frequency AC analysis while sweeping the voltage of the DC course. Plot the voltage across the switch. The magnitude will equal the switch resistance. -Ken |
The Designer's Guide Community Forum » Powered by YaBB 2.2.2! YaBB © 2000-2008. All Rights Reserved. |