The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl Design >> Analog Design >> anti-aliasing filter for ADCs https://designers-guide.org/forum/YaBB.pl?num=1569936357 Message started by polyam on Oct 1st, 2019, 6:25am |
Title: anti-aliasing filter for ADCs Post by polyam on Oct 1st, 2019, 6:25am Hi, I have a very basic question. Do we need to use anti-aliasing filter (AFF) when SIMULATING Nyquist rate ADCs and switched capacitor sigma delta ADCs? How important is it to have AAF in simulation and chip measurement? Please elaborate. Thanks |
Title: Re: anti-aliasing filter for ADCs Post by Andrew Beckett on Oct 4th, 2019, 7:28am Presumably this depends on what you're simulating or measuring. If all your input frequencies are below the Nyquist rate, then it's not necessary to include the anti-aliasing filter. If you potentially have significant signal levels at frequencies above the Nyquist rate, or are trying to assess the effectiveness of your anti-aliasing filter, then yes you would... |
The Designer's Guide Community Forum » Powered by YaBB 2.2.2! YaBB © 2000-2008. All Rights Reserved. |