The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl Other CAD Tools >> Physical Verification, Extraction and Analysis >> Cap extraction of an IC PAD https://designers-guide.org/forum/YaBB.pl?num=1654702617 Message started by vlsi_design on Jun 8th, 2022, 8:36am |
Title: Cap extraction of an IC PAD Post by vlsi_design on Jun 8th, 2022, 8:36am Hi, I want to extract the capacitance of an IC PAD. Unfortunately there are no pins and I cannot pass lvs and do extraction. I may use a metal res to get a pin out and extract but are there better ways to do this? |
Title: Re: Cap extraction of an IC PAD Post by Maks on Jun 21st, 2022, 7:12am Yes - do LVS and extraction using layout only, without doing cross-referencing to schematic - and you can get your parasitics for your design (do not create shorts or opens, or other wrong things - in which case, the results will be meaningless). |
The Designer's Guide Community Forum » Powered by YaBB 2.2.2! YaBB © 2000-2008. All Rights Reserved. |