Frank Hayden
Guest
|
Hello There;
I am wondering why I get a 10 dB difference when I simulate IIP3 using the method that was published on this site ( Accurate and Rapid Measurement of IP2 and IP3, version 1b, 22 May 2002) and the method of two tone IIP3 simulation using transient analysis. I trust the transient analysis approach more than the PAC/PSS method, as this is the way I would measure it.
Has anyone had any experience with either of these methods, and can you make any rcommendations?
Thank you in advance.
Frank Hayden
|