The Designer's Guide Community
Forum
ForumVerilog-AMSAnalysisModelingDesignTheory
Welcome, Guest. Please Login or Register. Please follow the Forum guidelines.
Sep 29th, 2024, 4:22pm
 
  HomeHelpSearchLoginRegisterPM to admin    
The Designer's Guide Community Forum › Design › Analog Design › IC charger
‹ Previous topic | Next topic ›
Pages: 1
Send Topic Print
IC charger (Read 2215 times)
grosser
Community Member
***
Offline



Posts: 57
IC charger
Jul 14th, 2007, 1:21pm  
hello

i'm looking articles or books about Li-ion battery charger. it has to consume small current. how battery capacity influences stability and what battery model should i use

regards
Back to top
 
 
View Profile   IP Logged
qiushidaren
Community Member
***
Offline

I am a lovely
MOSFET!

Posts: 86
Chengdu
Re: IC charger
Reply #1 - Jul 16th, 2007, 6:57pm  
If Ken doesn't mind, I will recommend you to go to www.edaboard.com to take a look.

-Terry
Back to top
 
 
View Profile WWW   IP Logged
fehler
New Member
*
Offline



Posts: 9
Re: IC charger
Reply #2 - Aug 19th, 2007, 7:05am  
you can model it with a very large cap, say 1F. then the bat is just a ground in small signal.

grosser wrote on Jul 14th, 2007, 1:21pm:
hello

i'm looking articles or books about Li-ion battery charger. it has to consume small current. how battery capacity influences stability and what battery model should i use

regards

Back to top
 
 
View Profile   IP Logged
Pages: 1
Send Topic Print
‹ Previous topic | Next topic ›
« Home ‹ Board
The Designer's Guide Community Forum » Powered by YaBB 2.2.2!
YaBB © 2000-2008. All Rights Reserved.
Copyright 2002-2024 Designer’s Guide Consulting, Inc. Designer’s Guide® is a registered trademark of Designer’s Guide Consulting, Inc. All rights reserved. Send comments or questions to editor@designers-guide.org. Consider submitting a paper or model.