The Designer's Guide Community
Forum
Welcome, Guest. Please Login or Register. Please follow the Forum guidelines.
May 24th, 2019, 8:58am
Pages: 1
Send Topic Print
receiver characterization in CCS (Read 3168 times)
c1000
Junior Member
**
Offline



Posts: 16

receiver characterization in CCS
Jan 18th, 2011, 3:12pm
 
receiver characterization in CCS

   I read the white paper of Synopsys's CCS (composite current source model) model, but I can't understand the receiver model of CCS.
   In the paper, it is said the receiver consists of C1 and C2. C1 is used before the delay trip point has been reached and C2 is used after the delay trip point has been reached.

   so there is no miller cap in receiver?
   C1 and C2 are both ground cap connected to input node?
   In the simulation, the capacitance of receiver is switched between C1 and C2, it will produce noncontinuous waveform due to the sudden change.
   then I feel confused.

   Please help me!
Back to top
 
 
View Profile   IP Logged
Pages: 1
Send Topic Print
Copyright 2002-2019 Designer’s Guide Consulting, Inc. Designer’s Guide® is a registered trademark of Designer’s Guide Consulting, Inc. All rights reserved. Send comments or questions to editor@designers-guide.org. Consider submitting a paper or model.