The Designer's Guide Community
Forum
Welcome, Guest. Please Login or Register. Please follow the Forum guidelines.
Mar 29th, 2024, 1:32am
Pages: 1
Send Topic Print
UltrasimVerilog error: failed to parse the netlist (Read 45 times)
ahhfyz
New Member
*
Offline



Posts: 5

UltrasimVerilog error: failed to parse the netlist
Jan 12th, 2012, 11:00pm
 
Hi, everyone!
I have a system including verilog (modules and sub-modules) and schematic. It can be simulated in SpectreVerilog, but failed in UltrasimVerilog:
"Error found by UltraSim.
ERROR (USIM-18610): The UltraSim simulator failed to parse the netlist.
Correct the above errors and run the simulation again."

What should I do next? Thank you!

Back to top
 
 
View Profile   IP Logged
AMS_ei
Community Member
***
Offline



Posts: 67

Re: UltrasimVerilog error: failed to parse the netlist
Reply #1 - Aug 2nd, 2016, 4:49am
 
Hi,

Please use the following two lines and check if it works.

-sysv_ext +.v
-simcompatible_ams spectre

Thank you.
Back to top
 
 
View Profile   IP Logged
Pages: 1
Send Topic Print
Copyright 2002-2024 Designer’s Guide Consulting, Inc. Designer’s Guide® is a registered trademark of Designer’s Guide Consulting, Inc. All rights reserved. Send comments or questions to editor@designers-guide.org. Consider submitting a paper or model.