The Designer's Guide Community
Forum
Welcome, Guest. Please Login or Register. Please follow the Forum guidelines.
Jul 19th, 2019, 3:46pm
Pages: 1
Send Topic Print
Incorrect hierarchical Calibre PEXR extraction (Read 1226 times)
pazhasi
New Member
*
Offline



Posts: 3

Incorrect hierarchical Calibre PEXR extraction
Jul 05th, 2016, 2:35am
 
Hello all,

While doing Hierarchical extraction with Calibre PEXr, i am encountering incorrect dc currents. almost 80%less. I am blackboxing a component which is connected to the source of the MOS and the interconnect between source and the pin of the component is showing 20mV (which ideally should be zero) and hence the current is less.. Any ideas ?.. In calibre pex, hcells of the component is added and the LVS box command is used. The PEX finshes without any error..

Back to top
 
 
View Profile   IP Logged
Pages: 1
Send Topic Print
Copyright 2002-2019 Designer’s Guide Consulting, Inc. Designer’s Guide® is a registered trademark of Designer’s Guide Consulting, Inc. All rights reserved. Send comments or questions to editor@designers-guide.org. Consider submitting a paper or model.