The Designer's Guide Community
Forum
ForumVerilog-AMSAnalysisModelingDesignTheory
Welcome, Guest. Please Login or Register. Please follow the Forum guidelines.
Apr 19th, 2024, 2:46pm
 
  HomeHelpSearchLoginRegisterPM to admin    
The Designer's Guide Community Forum › Design › Mixed-Signal Design › Moved: POLY1 must be covered by N+ or P+ implant layer @Umc40lp using Calibre
‹ Previous topic | Next topic ›
Pages: 1
Send Topic Print
Moved: POLY1 must be covered by N+ or P+ implant layer @Umc40lp using Calibre (Read 813 times)
Ramakrishna RSSM
Junior Member
**
Offline



Posts: 12
Moved: POLY1 must be covered by N+ or P+ implant layer @Umc40lp using Calibre
May 7th, 2017, 2:44am  
This Topic has been moved to Physical Verification, Extraction and Analysis by Ken Kundert.
Back to top
 
« Last Edit: May 07th, 2017, 11:22am by Ken Kundert »  
View Profile   IP Logged
Pages: 1
Send Topic Print
‹ Previous topic | Next topic ›
« Home ‹ Board
The Designer's Guide Community Forum » Powered by YaBB 2.2.2!
YaBB © 2000-2008. All Rights Reserved.
Copyright 2002-2024 Designer’s Guide Consulting, Inc. Designer’s Guide® is a registered trademark of Designer’s Guide Consulting, Inc. All rights reserved. Send comments or questions to editor@designers-guide.org. Consider submitting a paper or model.