The Designer's Guide Community
Forum
Welcome, Guest. Please Login or Register. Please follow the Forum guidelines.
Mar 28th, 2024, 12:39pm
Pages: 1
Send Topic Print
Noise Figure in switched cap, with Pnoise (Read 1004 times)
sparky
New Member
*
Offline



Posts: 9

Noise Figure in switched cap, with Pnoise
Aug 13th, 2021, 3:28am
 
Hi, I am trying to get Noise Figure in track and hold circuit with RC>>Ts/2 as shown in added image.

NF= 10logF,  where F is Noise Factor
and F = (Ni+Nsys)/Ni.

In my circuit Nsys =0 (Sys include only switch and cap, there is no res(noise generator)). so, F should be =1, so the Noise figure should be = 0.
But, cadence giving me F = 1.96  and NF = 2.92.

Please help, what I am doing wrong.  I have added image of schematic and setiing of PSS and Pnoise
Back to top
 

switch_ckt.png
View Profile   IP Logged
sparky
New Member
*
Offline



Posts: 9

Re: Noise Figure in switched cap, with Pnoise
Reply #1 - Aug 13th, 2021, 3:30am
 
pss analysis setting
Back to top
 

pss_001.png
View Profile   IP Logged
sparky
New Member
*
Offline



Posts: 9

Re: Noise Figure in switched cap, with Pnoise
Reply #2 - Aug 13th, 2021, 3:32am
 
Pnoise
Back to top
 

pnoise1_001.png
View Profile   IP Logged
sparky
New Member
*
Offline



Posts: 9

Re: Noise Figure in switched cap, with Pnoise
Reply #3 - Aug 13th, 2021, 3:33am
 
pnoise2
Back to top
 

pnoise2.png
View Profile   IP Logged
Frank Wiedmann
Community Fellow
*****
Offline



Posts: 677
Munich, Germany
Re: Noise Figure in switched cap, with Pnoise
Reply #4 - Aug 16th, 2021, 4:12am
 
Back to top
 
 
View Profile WWW   IP Logged
Pages: 1
Send Topic Print
Copyright 2002-2024 Designer’s Guide Consulting, Inc. Designer’s Guide® is a registered trademark of Designer’s Guide Consulting, Inc. All rights reserved. Send comments or questions to editor@designers-guide.org. Consider submitting a paper or model.