The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl Design >> Analog Design >> pss and pnoise simulation https://designers-guide.org/forum/YaBB.pl?num=1076602058 Message started by Rich on Feb 12th, 2004, 8:07am |
Title: pss and pnoise simulation Post by Rich on Feb 12th, 2004, 8:07am I'm praying for help! ??? I'm trying to run a pss and pnoise simulation of the track and hold example from the "Simulating SC Filters w/ SpecterRF" paper, but the simulator always exits with the error message: PSS analysis must be executed befor pnoise although the pss simulation works alone. can anybody help me, please? Rich ??? |
Title: Re: pss and pnoise simulation Post by Andrew Beckett on Mar 4th, 2004, 9:52am Have you by any chance set the analysis order on the Setup->Environment form? If you don't set this, it runs them in a sensible order. Unfortunately if you set this, and you miss out one of the analyses that you're running, it runs those first (I think), rather than trying to do them in the default order relative to the ones you've specified. There's a PCR for this, and I think it's been fixed now (possibly in IC5033, although I've not checked). Still, the workaround is to enter all the analyses, or none of them... Regards, Andrew. |
Title: Re: pss and pnoise simulation Post by Stefan Sahl on Apr 1st, 2004, 6:42am Just an insanity check. Do you have both pss and pnsoise analysis enabled? If you have that it should work. /Stefan |
The Designer's Guide Community Forum » Powered by YaBB 2.2.2! YaBB © 2000-2008. All Rights Reserved. |