The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl Measurements >> Phase Noise and Jitter Measurements >> which offset frequency to measure phase noise? https://designers-guide.org/forum/YaBB.pl?num=1078231955 Message started by zteic on Mar 2nd, 2004, 4:52am |
Title: which offset frequency to measure phase noise? Post by zteic on Mar 2nd, 2004, 4:52am Hi, all In phase noise windows, which offset frequency shoud I take to measure phase noise? I see some paper measure the phase noise in 100K Hz offset frequency. but I feel very confuse. such as a VCO. it oscillating frequency can be 500M Hz. but another VCO , it oscillating at 5M Hz. Should I alway measure their phase noise at 100K Hz offset ? Is this reasonable? |
Title: Re: which offset frequency to measure phase noise? Post by Paul on Mar 9th, 2004, 12:07pm Hi, The offset at which you should measure the phase noise depends on the specs of your application. The distance at which the phase noise is measured typically corresponds to the channel spacing of your RF comms protocol. Paul |
The Designer's Guide Community Forum » Powered by YaBB 2.2.2! YaBB © 2000-2008. All Rights Reserved. |