The Designer's Guide Community Forum

The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl
Simulators >> RF Simulators >> sensitivity calculation in SpectreRF
https://designers-guide.org/forum/YaBB.pl?num=1115840749

Message started by Sambuddha Bhattacharya on May 11^th, 2005, 12:45pm

Title: sensitivity calculation in SpectreRF
Post by Sambuddha Bhattacharya on May 11^th, 2005, 12:45pm

Hello:

I want to compute the sensitivity of an LNA's performance specifications to some parasitics extracted from the layout. Examples of the some of the performance specs are noise figure, gain(s21), IIP3 etc. Parasitics under consideration are the usual lumped R,L, Cs. The SpectreRF simulator is being used for designing the circuit. I wonder if one could use spectreRF in computing these sensitivities.

Any suggestions will be very helpful,
Cheers,
Sambuddha