The Designer's Guide Community Forum

The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl
Simulators >> Circuit Simulators >> Window caption of Virtuoso window
https://designers-guide.org/forum/YaBB.pl?num=1120065850

Message started by stephen on Jun 29^th, 2005, 10:24am

Title: Window caption of Virtuoso window
Post by stephen on Jun 29^th, 2005, 10:24am

The captions of Virtuoso windows are always like this:
"Virtuoso Schematic Reading: xxxx cell name". When the windows are minimized, the only part I can see is "Virtuoso Schematic Reading ...". If I have many of such windows open, it's hard to tell which one is which without clicking through all of them one by one. Is there any way to make the cell name shown at the begining of window caption instead of the end?

Other software like Microsoft Word all shows document names first and then software name.

Thanks.