The Designer's Guide Community Forum

The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl
Simulators >> Circuit Simulators >> variable tolerances in Spectre
https://designers-guide.org/forum/YaBB.pl?num=1121762788

Message started by saumi on Jul 19^th, 2005, 1:46am

Title: variable tolerances in Spectre
Post by saumi on Jul 19^th, 2005, 1:46am

Hi,

I am using Cadence ICFB environment for my spectre transient simulations.
Is it possible to specify different tolerances for different subcircuits in the
schematic? That is, if I want to simulate a mixed signal circuit, can the tolerance
for the digital control logic ckt be reduced to speed up the simulation?

Regards,
Saumitra

Title: Re: variable tolerances in Spectre
Post by Andrew Beckett on Jul 19^th, 2005, 10:54am

This can be done with UltraSim, but I don't think it's possible with spectre right now (unless something snuck in whilst I wasn't looking ;D

Andrew.