The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl Simulators >> AMS Simulators >> help~ for AMS simulator https://designers-guide.org/forum/YaBB.pl?num=1127377176 Message started by sucki on Sep 22nd, 2005, 1:19am |
Title: help~ for AMS simulator Post by sucki on Sep 22nd, 2005, 1:19am ??? ??? ??? hi, when I run the cadence AMS, "AMS Design Prep" (netlist compile) was passed, and without any errors. but when i start with "AMS run simulation", it shows a error message as follows: ncelab: *F,CUNOPN: Cannot open 5x configuration (adc.adc_top:config) --------------- The HDBDI interface was unsuccessful in opening the specified configuration. so, I can't start the simulation Would anyone please help me~ thankfull~ :) |
Title: Re: help~ for AMS simulator Post by Andrew Beckett on Sep 24th, 2005, 3:17am Had you saved the config from the hierarchy editor? I can imagine this error would occur if you've created a new config, gone through the design prep, but not saved the config. I've not done any checks or searches to see. I also assume you're running the simulation from the hierarchy editor AMS plugin? Is that right? Regards, Andrew. |
Title: Re: help~ for AMS simulator Post by bafiol on Oct 15th, 2007, 12:26am Hi, I have just got this problem. Do you know how to solve it. thanks |
The Designer's Guide Community Forum » Powered by YaBB 2.2.2! YaBB © 2000-2008. All Rights Reserved. |