The Designer's Guide Community Forum

The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl
Design >> Analog Design >> Channel Charge Injection Simulation
https://designers-guide.org/forum/YaBB.pl?num=1128665664

Message started by Raj on Oct 6^th, 2005, 11:14pm

Title: Channel Charge Injection Simulation
Post by Raj on Oct 6^th, 2005, 11:14pm

Hello All,
Can anyone tell me the way to simulate Channel Charge Injection. Does Spectre and SmartSpice support this?

Thanks in advance,
Packiaraj.V.

Title: Re: Channel Charge Injection Simulation
Post by juddy on Oct 23^rd, 2005, 11:44am

I am also Confused about this.
I wonder if the BSim3 model has corresponding parameters?
Anyboby Helps?

Title: Re: Channel Charge Injection Simulation
Post by ywguo on Oct 26^th, 2005, 3:16am

Hi,

I'm not familiar with BSIM3 model, but I'm sure that you will see channel charge injection if you simulate a MOS switch using SPICE like simulator. :)

Best regards,
Yawei

Title: Re: Channel Charge Injection Simulation
Post by Paul on Oct 26^th, 2005, 12:14pm

Hi,

I agree with Yawei. The MOS model you use may influence the accuracy of the injected charge, as different channel charge definitions are used throughout the device models.

Paul