The Designer's Guide Community Forum

The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl
Simulators >> Circuit Simulators >> AVANWAVES Help I can´t see Delta X.
https://designers-guide.org/forum/YaBB.pl?num=1131081544

Message started by negil on Nov 3^rd, 2005, 9:19pm

Title: AVANWAVES Help I can´t see Delta X.
Post by negil on Nov 3^rd, 2005, 9:19pm

Hi,

Does anybody knows what should I do to see Delta X in the window panel in Avanwaves.

I am measuring propagation delay but I can´t see Delta X when I click the output waveform with point to point measurement even though I have marked Delta X in Measurement lanel options.

Is there any other way to measure propagation delay in avanwaves than using Delta X?

Title: Re: AVANWAVES Help I can´t see Delta X.
Post by spiceoracle on Jan 5^th, 2006, 2:58pm

Are you trying to do a point to point measurement between two signals? If so, this is not possible in AvanWaves. The point to point measurement will only give you the delta between two points on the same signal.