The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl Simulators >> Circuit Simulators >> save operation region with spectre? https://designers-guide.org/forum/YaBB.pl?num=1131153643 Message started by Narya on Nov 4th, 2005, 5:20pm |
Title: save operation region with spectre? Post by Narya on Nov 4th, 2005, 5:20pm Hi guys, with spectre I tried to save the operation region of a MOS transistor using following statement: save M1:region However, spectre complained that "region" is an invalid parameter and ignored the statement. The "region" parameter is indeed listed as one of the operating-point parameters for BSIM3v3 model in spectre documentation. I tried several other op-point parameters such as gm and vth, and spectre worked well. So how can I save the operation region ONLY? Any help is appreciated, thanks a lot! |
Title: Re: save operation region with spectre? Post by rf-design on Nov 6th, 2005, 12:49pm I am not shure but if you type spectre -help bsim3v3 you will get a list of model/instance/op parameter. You have to possible use another syntax. |
Title: Re: save operation region with spectre? Post by Andrew Beckett on Nov 15th, 2005, 11:33am I just tried this, and you're right. It doesn't work. I found PCR 697454 which suggested it was fixed in MMSIM60 - but it doesn't seem to be when I tried it. I'll check why not... Andrew. |
The Designer's Guide Community Forum » Powered by YaBB 2.2.2! YaBB © 2000-2008. All Rights Reserved. |