The Designer's Guide Community Forum

The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl
Simulators >> Circuit Simulators >> DC simulation in Spectre
https://designers-guide.org/forum/YaBB.pl?num=1131653470

Message started by ganesh on Nov 10^th, 2005, 12:11pm

Title: DC simulation in Spectre
Post by ganesh on Nov 10^th, 2005, 12:11pm

I have two blocks in my schematic. Both the blocks are not connected in any way to each other. One of the blocks uses an ideal VCVS as a common mode feedback.
If this feedback goes crazy, the DC simulation results of the other block also goes crazy.

I do not know if this is enough information to answer the question. But if people require any details, I will be eager to give them more details.

Ganesh.