The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl Design >> Mixed-Signal Design >> switch capacitor integrator simulation https://designers-guide.org/forum/YaBB.pl?num=1134027466 Message started by c.h.zheng on Dec 7th, 2005, 11:37pm |
Title: switch capacitor integrator simulation Post by c.h.zheng on Dec 7th, 2005, 11:37pm for everone: I design a sc integrator on cadence spectre,but i don't know how to simulate it,please give me some advice,thanks very much. |
Title: Re: switch capacitor integrator simulation Post by Cri Azzolini on Dec 8th, 2005, 8:47am Hi Zheng, probably you want to simulate the frequency response of your filter. In this case I suggest you the analysis PSS and PAC which are the steady-state and AC analysis for a periodic circuit (like SC-filters). The circuit should be fed with a PAC signal (you can use "vsource" or "port" in "analogLib") and the output voltage can be plotted from ADE with Result-> DirectPlot-> MainForm. If you are not interested to the sidebands of the (sampled) output signal the "maximum sidebands" in PSS analysis and "harmonics" in PSS should be both set at 0 (base-band). Bye, Cri |
Title: Re: switch capacitor integrator simulation Post by c.h.zheng on Dec 9th, 2005, 11:23pm Hi Cri,thank you!i will try according to your ideas,but if you have some reference about sc simulation,can you share?my email address:wwwzhenghao@163.com,thanks! |
The Designer's Guide Community Forum » Powered by YaBB 2.2.2! YaBB © 2000-2008. All Rights Reserved. |