The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl Simulators >> Circuit Simulators >> Hspice - saving starting points https://designers-guide.org/forum/YaBB.pl?num=1139991557 Message started by Ingvar on Feb 15th, 2006, 12:19am |
Title: Hspice - saving starting points Post by Ingvar on Feb 15th, 2006, 12:19am Hi, I am wondering if there is any way to save points during Hspice simulation which can then later be used as starting points. For instance in Spectre you can start a new simulation from the end point of a old simulation (provided you haven't over written the final condition file). It think it also has some way of periodically saving points, say for instance every 10us of simulation time, so that you can later start a new simulation from any of these points. Is there any similar function in Hspice, and in that case how do you set it up? |
Title: Re: Hspice - saving starting points Post by KristinBeggs on Mar 1st, 2006, 6:26am Hspice has a .SAVE/.LOAD command pair that will do roughly the same thing. The .SAVE command will allow you to specify a file, a format type (.ic or .nodeset) and also a time at which you want to save the information. You can then use the .LOAD command to initialize future runs. Hope this helps - Kristin |
The Designer's Guide Community Forum » Powered by YaBB 2.2.2! YaBB © 2000-2008. All Rights Reserved. |