The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl Simulators >> Circuit Simulators >> spectre dc simulation to extract mosfet capacitanc https://designers-guide.org/forum/YaBB.pl?num=1141221479 Message started by horizon on Mar 1st, 2006, 5:57am |
Title: spectre dc simulation to extract mosfet capacitanc Post by horizon on Mar 1st, 2006, 5:57am Hello, I have a small question concerning sprectre. Is it possible to use the dc operating point calculated by spectre to extract the cgg cgs cgd ? I mean is it reliable ? Thank you for your answer Horizon |
Title: Re: spectre dc simulation to extract mosfet capaci Post by Geoffrey_Coram on Mar 6th, 2006, 8:26am Doesn't spectre report cgg, cgs, cgd as part of the operating point information? As to the "reliability" perhaps you are asking whether the BSIM3/4 operating point information reported in simulation will match the measurement? In which case, the answer is often no, but the simulator isn't at fault. BSIM3/4 models are known to produce non-physical capacitances, including negative transcapacitances. |
The Designer's Guide Community Forum » Powered by YaBB 2.2.2! YaBB © 2000-2008. All Rights Reserved. |