The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl Simulators >> Circuit Simulators >> SNR in Cadence 5.0.33 https://designers-guide.org/forum/YaBB.pl?num=1142778450 Message started by fran2k5 on Mar 19th, 2006, 6:27am |
Title: SNR in Cadence 5.0.33 Post by fran2k5 on Mar 19th, 2006, 6:27am Hello everybody, I would like to ask you how to calculate from simulations the SNR at the output of a sigma-delta modulator. I am currently using Cadence Spectre 5.0.33. Is there any way with the use of the Calculator? Thank you very much, frank2k5 |
Title: Re: SNR in Cadence 5.0.33 Post by sheldon on Mar 19th, 2006, 7:39am fran2k5, If SINAD is acceptable, then you can use the Spectre's Fourier analysis tool. Unfortunately, the analogLib implementation is incomplete and you will need to manually setup the Fourier analysis. Best Regards, Sheldon |
Title: Re: SNR in Cadence 5.0.33 Post by fran2k5 on Mar 19th, 2006, 8:14am Thank you Sheldon, could you please give me more details on how to use the fourier tool from analogLib? Thanks again, fran2k5 |
Title: Re: SNR in Cadence 5.0.33 Post by fran2k5 on Mar 19th, 2006, 8:39am Sheldon, I have tried the fourier tool but I do not think it can do the job. It only provides the magnitude and phase of harmonics for a specified fundamental frequency. Did I get anything wrong? Thanks, fran2k5 |
The Designer's Guide Community Forum » Powered by YaBB 2.2.2! YaBB © 2000-2008. All Rights Reserved. |