The Designer's Guide Community Forum

The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl
Simulators >> RF Simulators >> Corner Simulation
https://designers-guide.org/forum/YaBB.pl?num=1147794120

Message started by pthoppay on May 16^th, 2006, 8:42am

Title: Corner Simulation
Post by pthoppay on May 16^th, 2006, 8:42am

HI all,

I am doing corner simulation using the corner command in the analog enviroment, I have defined the process model style as a single model library file.

With these settings, How can i simulate for a corner for two different temperatures at the same time?

Regards,
Prakash.