The Designer's Guide Community Forum

The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl
Design >> Mixed-Signal Design >> Experience in optimization
https://designers-guide.org/forum/YaBB.pl?num=1151942794

Message started by Visjnoe on Jul 3^rd, 2006, 9:06am

Title: Experience in optimization
Post by Visjnoe on Jul 3^rd, 2006, 9:06am

Hello,

I'm trying out the built-in ELDO optimizer to optimize a certain circuit's performance. However, this can only be run in 1 corner and one should be aware not to converge to a design point that produces nice results in typical, but is bad over corners/Monte Carlo.

Anyhow, I was wondering if u have good/bad experience with using this kind op optimizers? I think Cadence also has this
(Neolinear heritage)...

Kind Regards

Peter