The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl Simulators >> Circuit Simulators >> How to simulate for input referred noise https://designers-guide.org/forum/YaBB.pl?num=1161184825 Message started by chviswanadh on Oct 18th, 2006, 8:20am |
Title: How to simulate for input referred noise Post by chviswanadh on Oct 18th, 2006, 8:20am Hello all, I need to verify a Fully differential difference amplifier for the input referred noise. I am using spectre simulator. Can somebody give inputs on this Thanks chviswanadh |
Title: Re: How to simulate for input referred noise Post by ACWWong on Oct 18th, 2006, 10:32am Use a differential test bench and do a noise analysis. See the following on this site: http://www.designers-guide.org/Analysis/diff.pdf and try spectre -h noise or looking at the cadence manuals. Also on this forum, there has been alot of previous talk about differential testbenches, i seem to recall jbdavid posted some good reponses recently... try searching... |
The Designer's Guide Community Forum » Powered by YaBB 2.2.2! YaBB © 2000-2008. All Rights Reserved. |