The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl Design >> RF Design >> mixer dc offset https://designers-guide.org/forum/YaBB.pl?num=1161574808 Message started by sivacha on Oct 22nd, 2006, 8:40pm |
Title: mixer dc offset Post by sivacha on Oct 22nd, 2006, 8:40pm hi all, how to measure the DC offset voltage for a mixer using spectreRF?? Thank you..... |
Title: Re: mixer dc offset Post by aaron_do on Oct 23rd, 2006, 1:50am DC offset arises due to imperfections such as device mismatch and LO imbalance. Therefore before you can simulate it you need to introduce some kind of mismatch such as LO phase and amplitude mismatch or transistor width/length mismatch. You may want to check out "DC Offsets in Direct-Conversion Receivers: Characterization and Implications" by R. Svitek and S. Raman, IEEE Microwave Magazine. Anyway I think you can just use a PSS analysis. Also remember for balanced topologies, some of the mismatches can cancel each other off... Aaron |
The Designer's Guide Community Forum » Powered by YaBB 2.2.2! YaBB © 2000-2008. All Rights Reserved. |