The Designer's Guide Community Forum

The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl
Design >> Mixed-Signal Design >> about two step adc missing code
https://designers-guide.org/forum/YaBB.pl?num=1161918503

Message started by jim on Oct 26^th, 2006, 8:08pm

Title: about two step adc missing code
Post by jim on Oct 26^th, 2006, 8:08pm

Hello all,

I am testing a 10bit two step adc chip ,the reference voltage Vref+=1.4v,Vref_=0.4v,Vmid=0.9v,power supply is 1.8v,process is 0.18um, test result shows there are missing code about 960(decimal),when I overdrive the reference voltage Vref+=2.0v,Vref_=0.6v,Vmid=1.3v, power supply change to 2.2v,there are no missing code. I suspicion the Vref_=0.4v is too low,which will lead to the comparator of flash adc work abnormal,because the Nmos Vth is 0.4v for 0.18um process, but the simulation is ok. Could someone tell me the real reason? Thanks in advance.

Best Regards,
Jim

Title: Re: about two step adc missing code
Post by Andrew Beckett on Oct 28^th, 2006, 7:28am

I think it's pretty hard to debug an ADC with such limited information about the type of design, architecture, and so on. There are so many factors that could influence this...

Regards,

Andrew.

Title: Re: about two step adc missing code
Post by loose-electron on Oct 29^th, 2006, 4:06pm

Agreed - You need a lot more information about what you have for circuits, etc before anyone can comment intelligently on this.

Some questions - has the simultions been modellled with parasitics and mismatch considerations? Is the problem clocking rate dependent?

And a million other questions need to be asked.