The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl Simulators >> Circuit Simulators >> Cadence simulation problem https://designers-guide.org/forum/YaBB.pl?num=1170664009 Message started by wccheng on Feb 5th, 2007, 12:26am |
Title: Cadence simulation problem Post by wccheng on Feb 5th, 2007, 12:26am Dear all, I have a question about the Cadence simulation setting. I hope you could help me. In our simulation, I need to edit the “input.scs” file. After I finished the edition and press the "RUN”icon in the Analog Design Environment Windows. The simulated result is same as the netlist I changed before. However, I run the "runSimulation” script file in the command prompt. It could give out the edited result. Why will it happen? How could I set that it could allow me to press RUN icon in ADE instead? Best Regards, wccheng |
Title: Re: Cadence simulation problem Post by bernd on Feb 5th, 2007, 2:01am I've you use the run icon or the run menu item ADE will take your previously netlisted design out of the machines memory. Try - "Simulation -> Netlist -> Recreate" - Edit the netlist - Run (run only!) the simulator again. The netlist recreate action will force ADE to use the netlist form disk. Bernd |
Title: Re: Cadence simulation problem Post by Andrew Beckett on Feb 6th, 2007, 4:23pm Why do you need to edit the netlist? Knowing that might allow me to give a better way of achieving what you're really tring to achieve. Regards, Andrew. |
The Designer's Guide Community Forum » Powered by YaBB 2.2.2! YaBB © 2000-2008. All Rights Reserved. |